5.21i Ellipitical Fitness Crosstrainer
Page 80
9. Remove the hitch pin and clevis pin from the lower end of the lift motor and remove the lift
motor from the unit.
10. Thread the lift motor yoke onto the replacement lift motor. Insert the retaining bolt, removed
in step 7, into the replacement lift motor and secure it with the retaining nut.
11. Set the replacement lift motor in its mounting position and secure it with the clevis pin and
hitch pin removed in step 9.
12. Reconnect the lift motor connector to its mating connector. Fasten the frame ground
connector to the frame with the screw removed in step 8.
13. Calibrate the lift motor per Procedure 5.3, steps 4-9.
14. Replace both front cover halves.
To Next Page
Loading...
