Precor 9.45i - Chapter 4 - Calibration Procedures; Procedure 4.1 - Calibrating the Lift Limit Switches, 9.45 (1 L)

9.45, 9.45i Treadmill
Page 17
Procedure 4.1 - Calibrating the Lift Limit Switches, 9.45 (1L)
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
1. If the treadmill is not already at zero percent incline, press any key when the CALIBRATE
LIFT PRESS ANY KEY prompt is displayed.
2. Using the ruler, measure the distance between the floor and the top of the front and back
ends of the side rail (see Diagram 4.1).
Note:
The distance between the floor and the top of the front end of the side rail should be 9 inches.
Diagram 4.1 - Treadmill Side Rail Measurement