9.45, 9.45i Treadmill
Page 12
Procedure 2.6 - Selecting United States Standard or Metric
Units
Selecting United States standard units causes data to be displayed in feet, miles and pounds.
Metric data is displayed in meters, kilometers and kilograms.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Choose one:
IF... THEN...
You wish to verify the measurement Continue with the next step
standard the treadmill is currently using
before you change the standard
You wish to change the measurement Skip to Step 5
standard the treadmill is using
Checking the Measurement Standard
3. Press ENTER until the WEIGHT indicator light appears.
4. Watch the number displayed in the left display window while you press the SPEED
▲ key
five or six times.
Note:
If the treadmill is using United States standard units, the numbers in the left display window are
displayed multiples of 5 (such as 160, 165, 170, 175, etc.). If the units are displayed in multiples
of 2 or 3, the treadmill set for metric units.
Changing the Measurement Standard
5. Press and hold STOP to return the PRECOR M9.45 banner.
6. On 9.45 (1L or 2P units), press the QUICK START and then the SPEED
▲ key. Hold both
keys for 3–5 seconds, then release. On 9.45 (3Y units), press keys RESET,5,6,7,1,
sequentially.
Note:
On 9.45 (1L or 2P units), releasing the QUICK START key before the SPEED
▲ key when you
perform the next step may cause the selected measurement standard to change to the alternate
To Next Page
Loading...
