9.45, 9.45i Treadmill
Page 46
Procedure 6.7 - Replacing the Speed Sensor (1L Units)
WARNING
Always turn off the circuit breaker and unplug the treadmill before you begin maintenance
operations.
Removing the Speed Sensor
1. Remove the hood.
2. Disconnect the speed sensor wire assembly from the lower PCA.
3. Remove the screw that secures the speed sensor to the sensor mounting bracket.
4. Remove the speed sensor from the mounting bracket.
Diagram 6.5 - Speed Sensor Mounting (1L Units)
Replacing the Speed Sensor
5. Position the speed sensor in the sensor mounting bracket.
6. Replace the screw that secures the speed sensor to the sensor mounting bracket.
7. Connect the speed sensor wire assembly to the lower PCA.
Flywheel
Speed Sensor
Motor
To Next Page
Loading...
