Precor 9.45i - Procedure 6.8 - Replacing the Speed Sensor (2 P & 3 Y Units)

9.45, 9.45i Treadmill
Page 48
Procedure 6.8 - Replacing the Speed Sensor (2P & 3Y Units)
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Speed Sensor
1. Remove the hood.
2. Disconnect the speed sensor wire assembly from the lower PCA.
3. Remove the screw that secures the speed sensor to the sensor mounting bracket.
4. Remove the speed sensor from the mounting bracket.
Replacing the Speed Sensor
5. Position the speed sensor in the sensor mounting bracket.
6. Replace the screw that secures the speed sensor to the sensor mounting bracket (see
Diagram 6.6).
Diagram 6.6 - Speed Sensor Mounting (2P & 3Y Units)
Flywheel
Speed Sensor
Target
Speed Sensor
Bracket
Motor