Precor 905e - Page 26

905E, 9.1, 9.10 Treadmills
Page 26
THEN . . . OTHERWISE . . .
Replace the upper PCA as described Continue with the next step.
in Procedure 6.1 of this appendix.
Re-Installing the Upper PCA
18. Replace the screws that secure the upper electronic chassis to the electronics housing
assembly.
19. Position the electronic console at its mounting position.
20. Replace the bolts and washers that secure the electronic console to the upper handrail
clamp.
21. Position the crank handle at its mounting position. Use the 1/8” allen wrench to tighten the
set screws that secure the crank handle to the top of the lift jack.
22. Check the operation of the treadmill as described in Section Three of this appendix.