Assembly of each piece of Discovery Selectorized equipment takes about 30 minutes. If this is your first time assembling this equipment, allow more time.
At least two people are required to assemble the equipment. DO NOT attempt assembly by yourself.
Precor recommends that the strength equipment be bolted down at all anchoring points. See Bolt equipment to the floor for more details.
Installation Requirements
Follow these installation requirements when assembling the unit:
• Unpack the box and assemble the equipment close to where you plan to use it.
• Locate the equipment at least 40 inches (1 meter) away from walls or furniture on
either side of the equipment, and 40 inches (1 meter) away from objects behind or in
front of the equipment.
• While tightening the fasteners, be sure to leave room for adjustments. DO NOT fully
tighten fasteners until instructed to do so.
• Set up the equipment on a solid, flat surface, so that it remains level and stable.
• Assemble the equipment on a solid, flat surface, so that it remains level and stable.
• DO NOT move the equipment without assistance.
Required Tools
• Torque wrench with tension to at least 150 ft-lb and can be fitted with the following
hex bits: 7/32-inch, 5/16-inch, 5/32-inch, 1/2-inch, 3/8-inch, #2 Phillips bit
• Socket wrench that can be fitted with the following sockets: 9/16-inch, 1-inch, and
3/4-inch
• 3/4-inch open-end wrench x 2
• 5/32-inch hex wrench
4
To Next Page
Loading...
Need help?
General
