Tighten all frame fasteners
Once you have completed assembly, make sure all loose bolts are fully tightened.
Refer to bullets (below) for bolt torques.
Note Begin with the bolts located on the cross support.
• Tighten the cross support bolts to 44 ft-lb (60 N-m) of torque using a
5/16-inch hex tip bit and a 1-inch wrench.
• Tighten the Base support (5-inch bolts) with 31 ft-lb (42 N-m) of torque
using a 7/32-inch hex tip bit and a 9/16-inch wrench.
• Tighten the base and cross support transition plate bolts with 44 ft-lb (60
N-m) of torque using a 5/16-inch hex tip bit.
Stabilize equipment
To prevent damage to the equipment foot, tighten it all the way
into the frame before moving the equipment.
Use the adjustable equipment foot to ensure the equipment sits level on the floor.
Note The equipment may have more than one adjustable foot. Use the same
instructions to stabilize equipment with multiple adjustable feet.
To adjust the equipment foot:
1. Turn the adjustable foot to the left or right until
the equipment sits level on the floor.
2. Gently rock the equipment to ensure that it is
level. If there is any movement, readjust the
foot.
6
To Next Page
Loading...
