5.33 Ellipitical Fitness Crosstrainer
Page 6
3. Watch the display as the LED test progresses. The test is programmed to display the
following LED illumination sequence:
a. The test name “DISPLAY” will be displayed for 2 seconds.
b. The left half of the L.E.D. matrix illuminates.
c. The right half of the L.E.D. matrix illuminates.
d. All remaining L.E.D.’s, including the heart rate and annunciator L.E.D.’s illuminate.
4. If you do not observe the LED illumination sequences described in Step 3...
THEN... OTHERWISE...
Replace the upper PCA as described The LED test passed successfully;
in Procedure 7.2. continue with the next step.
5. Press the ENTER key to proceed to the keyboard test.
6. The test name “KEYBOARD” will be displayed for 2 seconds.
7. A graphical representation of all the keys on the keyboard will be displayed. When a key is
pressed the representation of the key will be turned “off”. Check all of the keys on the
keyboard in this manner.
THEN... OTHERWISE...
The keyboard test passed successfully; Troubleshoot the keypad and upper
continue with the next step. PCA as described in Procedure 6.2.
8. Press and hold the ENTER key to proceed to the heart rate test.
9. The test name “HEART RATE” will be displayed for 2 seconds.
10. A chest strap heart rate transmitter or a heart rate test transmitter must be used in
conjunction with this test.
11. If no heart rate signal is being received, the message NO HR RCVR will be displayed.
12. When a heart rate signal is being received, unfiltered (U 123) and filtered (F 123) heart rate
signals will be displayed. All of the Smart Rate L.E.D.’s will turn on and the Smart Rate
L.E.D. associated with the heart rate being received will flash each time a heart beat is
detected.
13. Press the ENTER key to proceed to the brake test.
14. The test name “BRAKE” will be displayed for 2 seconds.
To Next Page
Loading...
