Precor M9.41si - Grounding Instructions

I
Canadian Daparlmant of Communications
"This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.”
“Le present appareil numerique n’emet pas de bruits radioeelectriques depassant les
limites applicables aux appareils numeriques de la class B prescrites dans le Reglement ^^
sur le brouitlage radioelectrique edicte par le ministere des Communications du Canada.”
Grounding Instructions
The M9.41si Low Impact Treadmill must be grounded. If it should malfunction or break
down, grounding provides a path of least resistance for electric current which reduces
the risk of electrical shock. The treadmill is equipped with a power cord having an
equipment-grounding conductor and a grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and grounded in accordance with all local
codes and ordinances.
DANGER
Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service person if you are in doubt as
to whether the treadmill is properly grounded. Do not modify the plug provided with the
treadmill—if it doesn’t fit the outlet, get a proper outlet installed by a qualified technician.
The treadmill is for use on a nominal 120-volt circuit (refer to the WARNING below and
to the Installation Requirements on page 3) and has a grounding plug that looks like the
plug illustrated In Diagram A.
WARNING
This product is rated for use on a circuit having a nominal rating of 120 volts, 15 amps
and is factory-equipped with a specific electric cord and plug to permit connection to a
proper electric circuit. Make sure that the product Is connected to an outlet having the
same configuration as the plug. No adapter should be used with this product. If the
treadmill must be reconnected for use on a different type of electric circuit, the
reconnection should be made by qualified service personnel.
ATTENTION: Haute Tension
Ddbranchez avant de rdparer