page 21
COMMERCIAL PRODUCTS DIVISION
• Turn the height adjustor clockwise to raise the height of the front end.
• Turn the height adjustor counterclockwise to lower the height.
Once you have the proper height adjustment, use the wrench to turn the
nut counterclockwise and tighten it securely against the base tube.
23. Clean the ramp. Diagram 17. Wipe down the ramp and foot pedals with a
soft cloth dampened in a diluted solution of mild soap and water.
CAUTION: If you purchased the POLAR
®
chest strap option, be sure
to test the heart rate display (refer to page 22) prior to inserting the front
end cap.
24. Once you have checked that the heart rate feature is working properly, insert
the front end cap (found in the Hardware kit) into the base assembly. See
Diagram 18. Insert the front end cap into the base tube. Make sure that the
cable does not get pinched by the end cap. If necessary, use a rubber mallet
to secure the end cap.
SUPPLYING POWER TO THE EFX
®
The EFX does not require an electrical power connection. It has an internal battery
that is recharged every time a user works out for a reasonable period of time. A
pedaling speed above 40 strides per minute must be maintained for several seconds
before the Precor banner appears on the display. Once the banner appears, the user
can press QuickStart or Enter to begin working out. For more information, refer to
page 30,
Exercising on the EFX
.
Diagram 18
Insert the front
end cap.
Upright support
Front end cap
To Next Page
Loading...
