page 46
COMMERCIAL PRODUCTS DIVISION
USING CSAFE STANDARD EQUIPMENT
The EFX
®
is fully compatible with CSAFE protocols. Once the unit is connected
to a CSAFE master device and the user maintains a stride rate above 40 strides
per minute, the user is prompted for a user ID.
Note: If the optional battery recharger is plugged into the EFX and connected to
an appropriate power source, then no pedaling is necessary for user ID entry.
Five zeros appear on the display. The left zero indicates that it is awaiting input.
The following table provides information about the keypad functions:
User ID Entry: Program Keys
▼ or ▲ moves the blinking LED from field to field.
Numeric keypad use the number keys to enter a user ID. The number that
is pressed appears in the display and the next field be-
gins to blink. When all five user ID numbers are selected,
the user must press Enter to submit it.
Enter submits the displayed user ID. Note that if the five zeros
are being displayed when the user presses Enter, the
user ID entry is bypassed and the Course prompt ap-
pears.
Reset resets the display to the Precor banner.
A message indicates when the user ID is accepted by the CSAFE master
device. Then, the course prompt is displayed. See
Quick Steps to Working Out
on page 36.
Important: If the user’s stride rate drops below 40 strides per minute while using
the CSAFE device connection, a prompt PEDAL FASTER appears. If the stride
rate remains below the 40 strides per minute threshold for the next twenty sec-
onds, the CSAFE connection is terminated. The word RESETTING appears on
the display while the EFX disconnects from the CSAFE device.
To review information about CSAFE specifications, visit the web site at:
www.fitlinxx.com/csafe
If you have questions or need technical support, refer to
Obtaining Service
on
page 7.
To Next Page
Loading...
