26 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
CAUTION: Do not move the AMT off of its shipping pallet without
assistance. Do not apply any weight or other force to the side
arms of the AMT until the side arm supports have been installed.
To avoid unnecessary movement of the foot plates, do not
position the handlebars until instructed to do so.
To move the AMT from the pallet to its intended location:
1. Remove and discard the two fasteners securing the front
frame tube of the AMT to the shipping pallet, as shown in
the following figure.
Figure 9: Front pallet anchor locations
2. Lift the back end of the center support and roll the AMT
forward while your assistant stabilizes its front end and
guides it off the shipping pallet onto the floor.
3. Move the AMT ahead to its intended location.
4. Insert the end caps into the front frame tube. If necessary,
use a rubber mallet to tap them into place.
To Next Page
Loading...
