Precision Series / Energy Series Treadmill Owner's Manual: TRM 425 / 223 22
Connecting Your Audio Player
The reading tray at the top of your display console can
also hold an audio player or a tablet. If you connect
your device to the console, you can use the console’s
headphone connector and volume controls to listen to
your music without interrupting your workout.
Note: You will need a connecting cable with miniature
(3.5 mm) stereo headphone plugs on both ends.
To connect your audio player or tablet to the display
console:
1. Gently pull open the access cover on the back of
the console, as shown in the following figure.
Figure 10: Opening the access cover
2. Feed one end of the connecting cable through the
opening in the reading tray.
3. Insert the plug on the lower end of the cable into
the jack on the back of the console.
4. Close the access cover.
5. Plug the other end of the cable into your audio
player or tablet.
Tip: You can get excess cable out of the way by
feeding it through the opening in the reading tray.
To Next Page
Loading...
