Completing Assembly
13
Completing Assembly
Once initial assembly is complete, there are a few things to do before the treadmill
can be used:
Attach the stop key
Remove protective film
Level the treadmill
Check the alignment
Adjust the running belt
Break in the equipment
Attaching the Stop Key
The magnetic stop key fits into the nest on the stop switch assembly at the base
of the console.
Figure 19: Stop key placement
For more information on using the emergency stop function and the safety clip,
see the product Owner’s Manual.
Removing the Protective Film
The treadmill ships with a protective film over the Precor logos and on the face of
the console. To remove the film, grasp the edge of it and peel it off the equipment.
To Next Page
Loading...
