Treadmill 200 Series Assembly Guide 8
Tightening the Fasteners
Tighten the base screws in the order presented below.
To tighten the base fasteners:
1. Fully tighten the four front screws (two on each upright support) using the
5 mm hex key.
2. Use the 6 mm T-handle hex wrench to tighten the two side screws on each
upright support.
3. Use the 5 mm hex wrench to fully tighten the six screws that secure the
handrail assembly to the upright supports.
To Next Page
Loading...
