14
www.pregis.com 38-OM225-1
1. Press one of the preset buttons (a,
b or c) - the display will change to
the preset value.
2. Press the black ‘Run’ button to
initiate the cycle.
Instructions for Use
3. Remove any material from the outfeed
channel.
Check there is ample space for
the packs to discharge from the
outfeed channel.
Press the black ‘Start’ button to initiate
the cycle.
A preset quantity and length of pack are produced (three preset buttons available).
Preset Button Operation
NOTE: If the quantity is set above 99, the display will
show paper runs out, or the machine is stopped.
and will run continuously until the
To Next Page
Loading...
