MAX-PRO Operator Manual
Original Printed in English
This label on the Sharp MAX-PRO is placed where
there is potential of injury due to pinch points or mov-
ing parts. Make certain electrical power is disconnect-
ed before removing any guards and/or panels.
Risk Of Fire - Correct Fuse Replacement
The following labels are located in the proximity of a
fused circuit. Be certain to replace blown fuses ONLY
with fuses with the same electrical rating. Always dis-
connect electrical power before removing any guards
and/or panels and servicing the Sharp MAX PRO.
Fork Lift Use Label
These labels are placed next to the lifting points for
the Sharp MAX-PRO bagger. Only lift this bagger with
a Fork Lift at these points.
LIFTING PROCEDURE
The only approved lifting of this bagger is with a Fork-
lift through the Base of Frame Assembly. Forklift Use
Labels are on sides of Base to indicate the lift points.
EQUIPMENT SAFETY FEATURES
1-4
SECTION 1 - INTRODUCTION
To Next Page
Loading...
