Page 9 of 20
STEP 7
Estimated Time: 5 minutes
Using JCB connectors, and the Allen Key provided,
attach each lower stabilizer (B4), one at a time, to both
inner gables BELOW the drawer slide
Identifying the Lower Stabilizer
The screw hole is at the top, close to the finished edge
IMPORTANT
Finished edge
If you have any difficulty tightening the JCB connector,
use a screwdriver to adjust the JRN nut to make sure
the hole is facing the opening for the connector
JCB
Connector
JRN
Nut
B4
B4
To Next Page
Loading...
