4
2020 Voxx Electronics Corporation. All rights reserved.
Entering the Vehicle while it is Running via Remote Vehicle Start (Optional)
1. Unlock the vehicle’s doors.
2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3. Insert the key into the ignition switch and turn to the ON or RUN position.
4. Press the brake pedal. The remote vehicle starter will disengage and the
vehicle will operate normally.
NOTE: This feature may not be available on all vehicle makes/models. In some
vehicle applications the remote start will shut down upon entering the vehicle and
the engine will stop running. For these applications it will be necessary to restart the
vehicle normally. Refer to installing dealer for details.
Security Upgrade (Optional)
System Arm
To Arm and lock the vehicle doors press and release the button. The LED on the
antenna will ash slowly while armed.
System Disarm
To Disarm and unlock the vehicle doors press and release the button.
System Override
To disarm the system without the use of the remote control locate the valet override
button on the windshield mounted antenna.
1. Enter the vehicle.
2. Turn the vehicle ignition to the ON position.
3. Press and release the valet button in the antenna one (1) time.
The system is not disarmed and will remain disarmed until the button is pressed.
Valet Mode
Valet mode allows the user to Lock or Unlock the vehicle without Arming the security
system. To enter or exit valet mode:
1. Turn the vehicle ignition to the ON position.
2. Press and hold the valet button for ve (5) seconds. The LED on the antenna
will turn on solid when Valet Mode is active.
To Next Page
Loading...
