Prestige APS57TM - Remote Control Programming and Batteries; Remote Control Programming; Replacing Remote Control Batteries

6
2020 Voxx Electronics Corporation. All rights reserved.
Remote Control Programming
Replacing Remote Control Batteries
1. Cycle the vehicle ignition ON.
2. Press and release the valet/programming button three (3) times.
3. Press button of each transmitter you wish to program, the LED’s will
ash to conrm each transmitter.
4. Turn the vehicle ignition OFF.
NOTE: This system has one (1) button programming which programs all
channels of the system.
NOTE: The system will hold up to four (4) transmitters in memory,
programming a 5th transmitter will erase the oldest transmitter in memory.
1 Button Remote Control - Model 183BP
The CR2032 battery inside each remote control should last approximately one
(1) year under normal use. When the battery becomes weak you will notice the
remote control range (the distance from the vehicle the remote control will work)
deteriorate and the small LED on the remote control will dim. To replace the
remote control batteries:
1. Using a coin, disassemble the halves of the remote control.
2. Remove the old battery, observing the +/- symbols on the batteries and
replace with a new battery.
3. Reassemble the halves of the remote control.
4. Test operation of the remote control.