Prestige Solo - Page 32

EN • 32
ENGLISHFRANCAISNEDERLANDSESpAñoLITALIANoDEuTSCH
664Y2300.C
mCBA pARAmETERS FoR THE SpECIALIST
Factory setting
Key Screen Description of parameters Solo Excellence
STEP
Central Heating modulation hysteresis enabled
STEP
Central Heating modulation hysteresis disabled
STEP
Domestic hot water modulation hysteresis
enabled
STEP
Domestic hot water modulation hysteresis
disabled
STEP
Detection of domestic hot water hysteresis
enabled
STEP
Detection of domestic hot water hysteresis
disabled
STEP
Central Heating blockage time
[sec. x 10,2]
STEP
Domestic hot water blockage time
[sec. x 10,2]
STEP
Domestic hot water Central Heating
blockage time [sec. x 10,2]
STEP
Re-modulate the difference T1 - T2
STEP
Shell address
[-1 = disabled]
STEP
Temperature increase set point
for the production of hot water
STEP
first position:
2nd heating circuit:
0 = disabled
1= enabled [slave]
2 = enabled [master]
Second position:
the demand for heat comes from:
0 = the room thermostat
1 = the outdoor sensor