Wireless installation
1� Switch on your router before starting the network installation�
2� Plug the POWER cord and switch it on from the rear panel�
3� Press
to turn the power on�
4� Press INPUT switch to PC source�
5� Detected Wi-Fi networks will be listed in the Wi-Fi networks section on the right-hand
corner of the status bar�
6� Tap the desired Wi-Fi network you want to connect�
- If you selected a secured network, you’ll be asked to enter the network key or
password�
•A wireless LAN connection and performance cannot be guaranteed for all
residential environments� In the following cases, the wireless LAN signal
may be poor or drop, or the connection speed may become slow�
- When used in buildings made with concrete, reinforced steel, or metal�
- When placed near objects that obstruct the signal�
- When used with other wireless devices that emit the same frequency�
- When used in the vicinity of microwave ovens and other devices
that emit a magnetic field, electrostatic charge, or electromagnetic
interference�
•Make sure the firewall in your network allows access to the MultiBoard
wireless connection�
•Operations cannot be guaranteed when used with access points that do
not have Wi-Fi® certification�
•A wireless LAN access point is required to connect the MultiBoard to the
Internet using a wireless LAN� See the operation manual of your access
point for setup�
•A stable connection speed is required to play back streaming content�
Use a wired connection if the wireless LAN speed is unstable�
PMB554H847,707,657_QSG_ EN_no TV.indd 23 2013/10/15 14:29:06
To Next Page
Loading...
