Assembly completed. {
485(B)—11/19 — A4.4 For more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals, visit www.prevuepet.com
4
PIECES
Follow the assembly method from Step 3:
Place the side panel (L3) and the upper
back panel (B2) (no brackets) in place and
attach together with a hex screw in the
top bracket bottom hole.
Continue adding and attaching panels
[side panel (R3), upper front panel (F3)],
with hex screws in the top bracket
bottom holes.
Hook a ramp to the
underside of a platform.
Place the platform in
the lower level, on the
middle horizontal wire.
Remove the divider door. Hook a ramp on
the wire loops, and rest the other end on
the platform below. NOTE: The divider may
be replaced with the ramp installed.
At this point, go over the entire cage
and tighten up all screws until snug.
⁕
5
PIECES
interchangeable
]L
3
]R
3
]F
3
]Cr
]Ct
]B
3
× 10
Place the roof (CR) (with the
attached sliding door) in
position and attach with
a hex screw on each side.
Add the remaining
ramp and platform
in the upper level.
Add the hammock.
Rotate the windbell
lock up, to slide
the tray into place.
To Previous Page
Loading...
