PrimaLuceLab EAGLE3 - Telescope alignment and synchronization

PrimaLuceLab iSrl EAGLE2 User Manual
4) In the “ASCOM Telescope Chooser” window select “Proprierties” and the “ASCOM configuration” window will open. Set the right
number port in “Port” field and then press OK to close the window.
5) Then press OK in the “ASCOM Telescope Chooser” window and press “Connect” button in the “ASCOM interface” window. The red
button will become green and the EQMOD window will appear. Now you’re connected to the mount and you can remotely control it.
"
page !41
Actual telescope position