This chapter provides a quick overview of how to connect
the I21 integrated ampli er to other components in your
: Before connecting power check
that the required supply voltage, indicated
on the back panel, cor re sponds to your local
AC supply. If a different voltage is stated on
the type plate do not connect the I21 to the mains power,
and seek advice from your dealer.
Connect the mains power using the enclosed mains cable.
: Always disconnect the I21 and all other units in
the system from the mains power before connecting or dis-
connecting any of the cables. Never short circuit speaker
terminals. This might seriously damage the unit.
To prevent re or shock hazard, do not expose this
appliance to dripping or splashing. No objects lled with
liquids, such as vases, should be placed on the I21.
If you want to build in the I21 you need to be sure to
allow space of at least 20 cm behind, 10 cm on both sides
and 30 cm above the top panel of the unit. This is to pre-
vent re or damage caused by overheating. Also make sure
that the main switch is accessable.
Use the main switch under the left-hand edge of the
During normal operation you can leave the I21 switched
To switch on from standby or to standby
on the front panel or on the remote control,
will change the standby mode.
To Next Page
Loading...
