How to set a Smart-Sync Bridge back to Normal mode (Bton)
When a network is available, the device must be set to normal mode to allows its connection to the facility's network.
1.
Press and Hold the button for 3 seconds to exit No Network mode.
2.
Verify that Bton is displayed on the LCD.
3.
Power cycle the device - it then enters the 8-hour Deployment mode.
During Deployment mode, the first 8 hours after a Smart-Sync Bridge is powered on, its operation is unique during this time period.
l Smart-Sync Bridge automatically connects to the facility's network at the 15th and 45th minute of each hour. During each
connection, it obtains UTC time from a NTP Server and checks-in to OneVue to download pending setting changes.
l Smart-Sync Bluetooth Network automatically builds at the 20th and 50th minute of each hour. After each build, a Smart-Sync
Bridge automatically checks-in to OneVue to send received Smart-Sync Clock data.
4.
Press and release the Check-in button to initiate a manual check-in to validate the device can connect to your facility’s
network and OneVue account. The LCD displays a series numbers indicating its connection sequence.
Number 1 displayed - radio powered on
Numbers 12 displayed - connected to facility's Ethernet or Wi-Fi network
Numbers 123 displayed - connected to NTP Server and obtained UTC Time
Numbers 1234 displayed - connected to OneVue; sends Smart-Sync Clock statuses to OneVue and downloads update pending
settings
5.
Verify the device LCD displays Signal OK and Bton (normal mode). Signal Ok indicates the device has successfully connected to
your facility's network.
14
To Next Page
Loading...