540889_PUB_DATE_1_JUL_2011.DOC INSTALLATION, MAINTENANCE AND USER' MANUAL 35
Maintenance and adjustments
Tightening moments
The recommended torque values for standardized steel bolts:
M6 8.8: C = 10 Nm
M8 8.8: C = 25 Nm
M10 8.8: C = 45 Nm
M12 8.8: C = 80 Nm
M16 8.8: C = 200 Nm
Replacement washer fuses
Fuse values
The correct values of fuses can be found in the vicinity of the fuse holders and on the electrical scheme
and delivered with the machine. When a fuse is blown, you can replace it with the same value but in NO case
a higher value. If the fuse blows again, do not change it, but find the cause of the failure.
Contact your commercial distributor for help if necessary.
To Next Page
Loading...
