Use of the wrong cutting blade for which it was not designed may cause that blade to
shatter causing serious or fatal injury.
Only use the cutting blade approved for the type of material to be cut.
Diamond blades have a much better cutting performance than standard abrasive blades.
The blades are steel centered and diamond particles are imbedded in their cutting edges.
Wet or dry cutting is possible. Cutting wet will extend the life of your diamond blades. A
water attachment comes as standard equipment with the EHS350A. Before using the
water attachment make sure that the screw that secures the outlet tube is tightened.
Always install the blade so that the arrow on the blade points in direction of the rotation of
the spindle.
Before carrying or transporting your cut-off machine the engine must be off. Never leave
the engine running whilst unattended, e.g. on the ground.
12
To Next Page
Loading...