Proper tension of the V-belt is important. In order to avoid a false setting, the tensioning
procedure must be followed as described in your manual. Always make sure the hexagonal
collar nuts for the cast arm are tightened securely. Check V-belt tension after one hour of
operation and correct if necessary.
3. Operator:
. The cut-off saw is a one–person tool. So start and operate this saw without
assistance.
. Make sure you are in good physical condition and are not under the influence of any
substance such as drugs or alcohol which may impair vision or dexterity. Take
breaks as needed to prevent you from getting fatigued.
.
Never let the EHS350A saw run unattended. NO untrained personal should ever be
allowed to use a cut-off machine. Bystanders, especially children and animals
should not be allowed in the area where a cut-off machine is in use.
Do not lend or rent your cut-off machine without the Operation Manual. Employers
should establish a training program for operators of this saw to ensure safe operation
13
To Next Page
Loading...