c. Fitting/Replacing the blade: (Ref. Fig.5)
● Slide the locking pin (1) through the bore in the V-belt guard (2) (turn the blade
until the locking pin engages in one of the bores on the belt pulley (3).
● Use the combination wrench to loosen and unscrew the hexagon bolt (4).
● Remove the metal washer (5), the flange (6) from the arbor together with the
blade to be replaced.
● Mount the new blade (7).
● Fit the flange and metal washer.
● Screw in the hexagon bolt and tighten it with the combination wrench.
● Finally draw the locking pin out of the V-belt guard.
25
To Next Page
Loading...