1. Blade:
Diamond or abrasive blades. Depending on the material to be cut, these blades are
made of different materials. Be sure to choose right blade for the material being cut.
The maximum diameter of the blade for the saw is 14 inch. And the operating speed of
the blade should be above or equal to 5300 RPM.
2. Flanges:
Clamp and support the diamond or abrasive blade.
3. Hexagon Bolt:
Tightens blade flange.
4. Blade Guard:
Safety guard, directs sparks and dust away from operator.
5. Front Handle:
Used to securely hold the saw while under operation.
6. Spark Plug Cover:
A removable cover for access to the spark plug
7. Kill Switch:
Engine stops when this switch is pressed and held.
7
To Next Page
Loading...