Test the extruder with initial burn-in temperature
Set your Extruder temperature to 200 and click Set. When the temp has reached 200, open the
extruder latch and feed the lament down into the hot end opening at the hobbed bolt area.
For easier access, we recommend trimming the lament at an angle.
Troubleshooting
If you encounter any movement issues with your axis or extruder, double check the assembly
instructions and check the technical forum at www.printrbottalk.com for possible quick x
solutions. If you are unable to resolve the problem quickly, please open a support ticket.
18
To Next Page
Loading...
