Required and optional tools
Before you begin to assemble your bot, please note that you are going to need several tools.
Below is a listing of the typical tools used for assembling a Printrbot Plus. This list should cover
you for both the LC and jr as well, however there may be a few other items you will need to
purchase depending on which version Printrbot you have.
Phillips Screwdriver
8mm or 5/16 inch Wrench
1/2 inch Wrench
2.5mm Allen Wrench
1.5mm Allen Wrench
Hammer or Rubber Mallet
Wood or Super Glue
utility knife
at hand le
cordless drill
7/64" drill bit
9/64" drill bit
4" C Clamp
micro cutters
slim needle nose pliers
Assembly Instructions
Download the appropriate instructions for
your model from www.printrbot.com/
support/. We recommend using a
combination of both the Step by Step
Installation Guides as well as the Build Videos.
Our designs have changed slightly since the
time these instructions were originally
created. However, using these in tandem will
help to clarify the process during assembly.
Note: During the build process, some sub
assemblies (such as the extruder) are detailed
in their own build instructions.
Help During Assembly
If you get stuck during assembly, we recommend browsing our technical forum at
www.printrbottalk.com as we have several power users and moderators that can give you quick
assistance and troubleshooting help. However, if you are unable to resolve your issues please
open a support ticket at www.printrbot.com/support/.
6
To Next Page
Loading...
