28
b. If the walking belt slips when walked on, fi rst
remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walking
belt is correctly tightened, you should be able to lift
each edge of the walking belt 2 to 3 in. (5 to 7 cm)
off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power
cord, insert the key, and walk on the treadmill for a
few minutes. Repeat until the walking belt is prop-
erly tightened.
SYMPTOM: The tablet holder does not stay in
place
a. Rotate the tablet holder (D) until it faces backward.
Then, tighten the indicated screw (E) slightly until
the tablet holder stays in place when it is rotated to
the desired position.
D
E
a
b
To Next Page
Loading...
Need help?
General