14
10
10. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Orient the Pulse Crossbar (93) as shown. Attach
the Pulse Crossbar to the Handrails (86) with two
#10 x 3/4" Screws (9) and two #10 Star Washers
(5); start both Screws, and then tighten them.
Make sure not to pinch the Upright Wire (81)
or the handrail wires (J).
Next, firmly tighten the four 5/16" x 2 1/2"
Screws (28).
Then, remove the wire tie (A) from the Upright
Wire (81).
9
9
5
5
28
28
86
93
86
J
J
81
A
11
93
K
11
86
58
4
86
4
11
11. Hold the console assembly (K) near the Pulse
Crossbar (93). Connect the ground wire from the
console assembly to the Console Ground Wire
(58) on the Pulse Crossbar.
Next, set the console assembly (K) on the brack-
ets on the Handrails (86); do not pinch any
wires. Make sure that the handrail wires (J)
are oriented as shown.
Attach the console assembly (K) with the four
5/16" x 3/4" Screws (4) that you removed in step
8 and four 5/16" Star Washers (11); do not fully
tighten the Screws yet.
J
J
To Next Page
Loading...
Need help?
General