27
THE SETTINGS MODE
The console features a settings mode that keeps track
of treadmill usage information and allows you to select
a unit of measurement for the console.
To select the settings mode, insert the key into the
console while holding down the Stop button. Then,
release the Stop button. Note: If a workout has been
selected, you may have to press the Stop button twice
to exit the workout before you can access the settings
mode. When the settings mode is selected, the follow-
ing information will be shown:
An “E” for English miles or an “M” for metric kilometers
will appear in the display. Press the Speed increase or
decrease button to change the unit of measurement, if
desired.
Press the Stop button repeatedly until the display
shows the calibration screen. Press the Incline in-
crease or decrease button to calibrate the incline sys-
tem.
To exit the information mode, remove the key from the
console, or press stop repeatedly.
HOW TO USE THE TABLET HOLDER
IMPORTANT: The tablet holder is designed for use
with most full-size tablets. Do not place any other
electronic device or object in the tablet holder.
To insert a tablet into the tablet holder, set the bottom
edge of the tablet in the tray. Then, pull the clip over
the top edge of the tablet. Make sure that the tablet
is firmly secured in the tablet holder. Reverse these
actions to remove the tablet from the tablet holder.
Tablet
Holder
To Next Page
Loading...
Need help?
General