18
20
3
100
G
3
20. Attach the Tablet Holder (100) to the console
assembly (G) with four M4 x 16mm Screws (3);
start all four Screws, and then tighten them.
Do not overtighten the Screws.
21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the fl oor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 31 and 32). Note: Extra parts may be
included.
To Next Page
Loading...
