V1.0 PROCUT 30A Digi Plus Plasma Cutter 9085754
Visit www.princessauto.com for more information 25
For home workshop and light industrial users
the on-board air filter is adequate. Most
situations will require additional filtration to
prevent moisture from affecting the quality of
the plasma cutter. In most cases it is
recommended to install a submicronic
particulate filter that is designed to trap water
through absorption. This style of filter has a
replaceable filter cartridge that absorbs water
and must be changed as it nears saturation. It
should be installed close as possible to the air
intake of the plasma cutter.
TECHNIQUE TIPS
• To cut thin material reduce the amperage until you get the best
quality cut.
• Use the correct size tip orifice for the amperage being used.
• For straight cuts use a straight edge or cutting buggy as a guide. For
circles, use a template or circle cutting attachment
• Check that the front-end consumable parts of the plasma cutting
torch are in good condition.
PIERCING
Hold the torch at an angle to the workpiece, pull the trigger to start the
arc and slowly rotate it to an upright position.
When sparks are exiting from the bottom of the workpiece, the arc has pierced
through the material. When the pierce is complete, proceed with cutting.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced by
an authorized technician. Only use identical replacement parts when
servicing.
3. Exposure to extremely dusty, damp, or corrosive air is damaging to
the plasma cutting unit. In order to prevent possible failure or fault of
this equipment, clean the dust at regular intervals with clean and dry
compressed air.
To Next Page
Loading...