pro.point PROCUT 30A DIGI PLUS - Specifications; Hazard Definitions

9085754 PROCUT 30A Digi Plus Plasma Cutter V1.0
2 For technical questions call 1-800-665-8685
SPECIFICATIONS
Skill Level
Low
Input Voltage
115/230 Single Phase 50/60Hz
Duty Cycle 35% @ 30A
60% @ 23A
100% @ 20A
Metal Type
Any conductive metal
Output Current
30A
Max. Amperage Draw
40A
Rated Cut Capacity
See Cut Thickness chart
Sever Capacity See Cut Thickness chart
Generator Compatible
Yes
Air Consumption
6 CFM (120 l/m) at 75 PSI
Working Temperature
-10 to +40°C (14 to 104°F)
Operational Humidity
Below 90% @ 20°C/68°F
Dimensions
21 x 6-1/2 x 13-1/2 in.
HAZARD DEFINITIONS
Please familiarize yourself with the hazard notices found in this manual. A
notice is an alert that there is a possibility of property damage, injury or
death if certain instructions are not followed.
DANGER! This notice indicates an immediate and specific hazard that
will result in severe personal injury or death if the proper
precautions are not taken.
WARNING! This notice indicates a specific hazard or unsafe practice that
could result in severe personal injury or death if the proper
precautions are not taken.
CAUTION! This notice indicates a potentially hazardous situation that may
result in minor or moderate injury if proper practices are not
taken.
NOTICE! This notice indicates that a specific hazard or unsafe practice
will result in equipment or property damage, but not
personal injury.