9085754 PROCUT 30A Digi Plus Plasma Cutter V1.0
14 For technical questions call 1-800-665-8685
ELECTROMAGNETIC FIELDS
WARNING! Stop welding immediately and move away from the
plasma cutting machine if you feel faint, dizzy, nausea or shocks.
Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such as
pacemakers. Anyone with a pacemaker should consult with their doctor
before working with or near an arc welding unit. The following steps can
minimize the effects of electromagnetic fields.
1. Twist or tape cables together and prevent coils.
2. Do not drape cables on your body.
3. Keep the welding power source and cables as far away from the user
as practical. A minimum of 24 in. is recommended.
4. Connect the workpiece clamp as close to the weld as possible but lay
the electrode and workpiece cables away from the user.
5. Use the appropriate current setting during cutting.
6. Avoid long and regular bursts of energy while welding. Apply the
electrode in short strokes and intermittently. This will prevent the
pacemaker from interpreting the signal as a rapid heartbeat.
7. Do not allow the electrode to touch the metal while welding.
8. Wrap the lead cable and ground cable together whenever possible.
9. Keep the lead cable and ground cables on the same side of your body.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in
a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Cutting Unit • 12 ft TRF45 Plasma Torch
• Air Regulator • Earth Clamp
• Fitted Plug • Adapter
To Next Page
Loading...