pro.point PROCUT 30A DIGI PLUS - Page 28

9085754 PROCUT 30A Digi Plus Plasma Cutter V1.0
28 For technical questions call 1-800-665-8685
Workpiece is
not cut
through.
1. The cutting speed is too
rapid.
2. Torch electrode or nozzle is
burnt out.
3. Cut thickness exceeds the
limit of the cutting unit.
4. Cutting mouth is not
vertical.
5. Leak from the gas circuit
reduces gas/air flow.
6. Incorrect amperage
selected.
1. Slow down the cutting speed.
2. Replace electrode or nozzle.
3. Replace with high-power
plasma cutting unit.
4. Adjust cutting mouth angle.
5. Examine and repair the gas
circuit.
6. Select correct amperage.
Power lamp
and
temperature
lamp on.
Air flow blocked or
components not functional.
1. Check fan for blockage.
2. Unit overheating. Allow time to
cool. Stay within duty cycle
limits.
3. Faulty components. Have unit
serviced.
Torch fails to
ignite or torch
arc shuts off
and won’t
restart.
1. Test Air mode selected
2. Machine is overheating.
3. Consumable torch
components worn out.
4. Air pressure too high or
low.
1. Switch to a cutting mode.
2. Allow time to cool. Stay within
duty cycle limits.
3. Replace worn components.
4. Adjust air pressure to 75 PSI.