Unpacking
The MT-7068 products come with the accessories listed below. If an accessory is damaged or missing
contact the place of purchase immediately.
MT-7068 Maintenance Kit
• MT-7068-T Toner with 9V battery and wrist strap
• MT-7068-R Probe with 9V battery and wrist strap
• 1 RJ45 (8 Pin) to RJ11 (6 Pin) patch cords
• 2 RJ45 (8 Pin) to RJ45 (8 Pin) patch cords
• F connector to BNC adapter, male to female
• F connector to RCA adapter, male to female
• Storage tool bag
• User's manual
Safety Information
Table 1 describes the international electrical symbols used on the tester and in this manual.
Table 1. International Electrical Symbols
Warning: Risk of personal injury. See explanations in the manual.
Caution: Risk of damage or destruction to equipment or software. See explanations in
the manual.
Warning: Risk of electric shock.
Please keep eye on the status or function of the equipment while operating.
This equipment not for connection to public communications networks, such as active
telephone systems.
Warning
• Never use the Toner or Probe on circuits of more than 100V.
• Never use the Toner, Probe, or test leads if they are damaged. Inspect the cases and test leads for dam-
age before use.
• Disconnect unused test leads and connectors from the Toner when testing telephone circuits.
• Never open the case except to change the battery or the fuse; no user-serviceable parts are inside.
• Turn off the Toner or Probe and disconnect all test leads before replacing the battery.
• Use only a 9V battery, properly installed in the case, to power the Toner and Probe.
• If this equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
Caution
• Avoid touching the Probe tip to patch panel connections and using the tip to dig into cable bundles. Doing
so regularly may damage the Probe tip over time.
• To avoid unreliable test results, replace the battery as soon as the low battery indication appears.
4
To Next Page
Loading...