Math Code
Linear 0
Log 1
Press Enter to save
Moisture: 3.3% 01
Algorithm (1=Log): 0
Moisture: 3.6% 01
Inst ID: 1
Instrument Network ID #
This line allows each sensor to be
given a discrete number, when
multiple sensors are connected
using RS485.
Moisture: 3.6% 01
Ser No.
Main Board Serial #
This lists the serial number of the
main circuit board installed in the
sensor.
Moisture: 3.6% 01
Total CLR EEPROM Y/N
Total CLR EEPROM
Selecting Y will set all the values
stored in EEPROM to their default
values.
Moisture: 3.6% 01
Sampler: Y/N
Sampler Mode
This line allows the sensor to be
set to operate in the Sampler
Mode. It requires the power
sampler accessory to be fitted to
the sensor. Refer to Appendix II
for full details of the smapler set-
up.
Moisture: 3.6% 01
MT 200 V2.11
Software Revision
This lists the revision of the
software fitted to the sensor.
To Next Page
