EasyManua.ls Logo

Procom MN100TPA-B - PRODUCT IDENTIFICATION; Component Diagram; QUALIFIED INSTALLING AGENCY; Installer Requirements

Procom MN100TPA-B
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.usaprocom.com
5200049-02A
QUALIFIED INSTALLING AGENCY
Only a qualied agency should install and re-
place gas piping, gas utilization equipment or
accessories. Repair and equipment servicing
should allways be done by a qualied agency.
The term “qualied agency” means any in-
dividual, rm, corporation, or company that
either in person or through a representative
is engaged in and is responsible for:
a) Installing, testing, or replacing gas piping
or
b) Connecting, installing, testing, repairing,
or servicing equipment; that is experienced
in such work; that is familiar with all precau-
tions required; and that has complied with
all the requirement of the authority having
jurisdiction.
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shuto󰀨 system. The
ODS/pilot shuts o󰀨 the heater if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This heater is equipped with a piezo ignitor.
this system requires no matches, batteries, or
other sources to light heater.
THERMOSTATIC CONTROL
(Thermostat Models Only)
These heaters have a control valve with a
thermostat sensing bulb. This results in the
greatest heater comfort and may result in
lower gas bills.
PRODUCT IDENTIFICATION
Figure 1 - Vent-Free Gas Heater
Control Knob
Ignitor
Button
Front Panel
Grill
Burners
Heater Cabinet

Related product manuals