EasyManua.ls Logo

Procom MN180HPA - User Manual

Procom MN180HPA
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VENT-FREE NATURAL GAS
SPACE HEATER
OWNER’S OPERATION AND
INSTALLATION MANUAL
INFRARED MODELS
MN180HPA, MN180TPA
MN300HPA, MN300TPA
Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 1-866-573-0674, 8:00 am - 4:30 pm CST,
Monday through Friday or email customerservice@usaprocom.com
WARNING: If the information in this manual is not
followed exactly, a re or explosion may result causing
property damage, personal injury or loss of life.
— Do not store or use gasoline or other ammable va-
pors and liquids in the vicinity of this or any other
appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re
department.
—
Installation and service must be performed by a quali-
ed installer, service agency or the gas supplier.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.

Table of Contents

Questions and Answers

  • R
    Roberta MccormickSep 9, 2025
    Why doesn't the burner plaque(s) glow on my Procom Gas Heater?
    • J
      jeremy58Sep 9, 2025
      If the burner plaque(s) on your Procom Gas Heater does not glow, the plaque might be damaged and need replacement. Also, the inlet gas pressure could be too low, so contact your local gas company. Ensure the control knob is locked at the desired setting, and not set between locked positions.
  • K
    Kaitlyn LaneSep 12, 2025
    Why does my Procom Gas Heater produce unwanted odors?
    • J
      John FischerSep 12, 2025
      Your Procom Gas Heater may produce unwanted odors if it's burning vapors from paint, hair spray, glues, etc. Ventilate the room and stop using odor-causing products while the heater is running. A gas leak could also be the cause, so locate and correct any leaks. If you're using propane, check for a low fuel supply and refill the tank if necessary.
  • J
    Jennifer BrownSep 13, 2025
    Why is there white powder residue forming within burner box or on adjacent walls or furniture when using Procom Gas Heater?
    • M
      Maria AllenSep 13, 2025
      If you notice white powder residue forming within the burner box or on nearby surfaces when using your Procom Gas Heater, it's likely due to heated vapors from furniture polish, wax, carpet cleaners, etc. Turn off the heater when using these products.
  • D
    Dr. David ConwaySep 15, 2025
    Why does my Procom Gas Heater produce a clicking/ticking noise just after burner is lit or shut off?
    • E
      Eric PhillipsSep 15, 2025
      The clicking or ticking noise your Procom Gas Heater makes after the burner is lit or shut off is likely due to the metal expanding while heating or contracting while cooling. This is normal for most heaters. If the noise is excessive, contact a qualified service technician.
  • G
    Gabriela FrancoSep 17, 2025
    Why is there slight smoke or odor during initial operation of Procom Gas Heater?
    • X
      xhudsonSep 17, 2025
      If you notice a slight smoke or odor during the initial operation of your Procom Gas Heater, it's likely due to residues from the manufacturing process. This problem should stop after a few hours of operation.

Procom MN180HPA Specifications

General IconGeneral
BrandProcom
ModelMN180HPA
CategoryHeater
LanguageEnglish

Related product manuals