Prodigit 3302F Mainframe - OCP: STEP Command; OCP: STOP Command; VTH Command; OPP: START Command

3302F Mainframe Operation Manual 49
OCP: STEP
Command Syntax:
[PRESet：] OCP:STEP {SP}{NR2}{；NL}
[PRESet：] OCP:STEP ？ {；NL}
Purpose: Set and read the increasing value of OCP Test
Description: This command is used for setting the increasing value (I-STEP) of OCP
Test.
OCP: STOP
Command Syntax:
[PRESet：] OCP:STOP {SP}{NR2}{；NL}
[PRESet：] OCP: STOP? {；NL}
Purpose: Set and read the maximum value of OCP Test
Description: This command is used for setting the maximum value (I-STOP) of OCP
Test.
VTH
Command Syntax:
[PRESet：] VTH {SP}{NR2}{；NL}
[PRESet：] VTH ? {；NL}
Purpose: Set and read the value of the Threshold Voltage
Description: This command is used for setting a minimum Threshold Voltage for the
OCP/OPP tests. If the measured voltage is below the threshold voltage
And the OCP/OPP test started the test will not run and an error will be
Flagged.
OPP: START
Command Syntax:
[PRESet：] OPP:START {SP}{NR2}{；NL}
[PRESet：] OPP:START ？ {；NL}
Purpose: Set and read the initial value of OPP Test
Description: This command is used for setting the initial value (P-START) of the OPP
Test.
OPP: STEP
Command Syntax:
[PRESet：] OPP:STEP {SP}{NR2}{；NL}
[PRESet：] OPP:STEP ？ {；NL}
Purpose: Set and read the increasing value of OPP Test
Description: This command is used for setting the power increments which the
OPP test will follow between the P-START and P-STOP values.
OPP: STOP
Command Syntax:
[PRESet：] OPP:STOP {SP}{NR2}{；NL}
[PRESet：] OPP:STOP ？ {；NL}
Purpose: Set and read the maximum value of OPP Test
Description: This command is used to set the maximum power value (P-STOP) of
The OPP test.