Profitec Pro 500 - Proper Usage Guidelines; Machine Components Overview; Identification of Machine Parts

ENGLISH
Translation of the German original user manual 20
2.2 Proper use
The PRO 500 has to be used for the preparation of coffee only, hot water and steam. The machine is not
intended for commercial use.
Use of the machine other than for the above mentioned purpose is strictly prohibited. The manufacturer
cannot be held responsible for damages due to unsuitable use of the machine and is not liable for
recourse.
This appliance is intended to be used in household and similar applications such as:
• staff kitchen areas in shops, offices and other working environments
• farm houses
• by clients in hotels, motels and other residential type environments
• bed and breakfast type environments
3. MACHINE DESCRIPTION
3.1 Machine parts
1 Cup warming tray; fresh water tank
underneath
2 Steam dispenser
3 Brew group
4 Green control lamp
5 ON/OFF switch
6 Boiler pressure gauge
7 Orange control lamp
8 Portafilter spout
9 Drip tray; PID display behind (see
image below)
10 Portafilter
11 Pump pressure gauge
12 Brew group lever
13 Hot water dispenser
The PID control of your Pro500 allows you to regulate the steam temperature and thus the boiler pressure
for steaming milk. The steaming temperature is factory pre-set to 120°C (248°F). Inherent to the design of
the machine, when modifying the steaming temperature, not only the boiler pressure but also the
extraction temperature of the coffee changes.
1
2
3
4
5
6
7
8
13
12
11
10
9
PID display behind the drip tray