ENGLISH
Translation of the German original user manual 21
Caution!
Danger of injury: The following parts are hot or may become hot:
• area around the steam handle and the hot water handle
• steam and hot water tube
• portafilter
• brew group
• body (upper part and side frames)
3.2 Technical data
Voltages: EU: 230 V Australia: 240 V
UK: 230 V US: 115 V
New Zealand: 240 V Japan: 100 V
Frequency: EU: 50 Hz Australia: 50 Hz
UK: 50 Hz US: 60 Hz
New Zealand: 50 Hz Japan: 50/ 60 Hz
Power: 1,400 W
Water tank: approx. 2.8 l
Measurements: w x d x h / 302 mm x 447 mm x 393 mm
Measurements
with portafilter: w x d x h / 302 mm x 555 mm x 393 mm
Weight: 23.5 kg
4. MACHINE INSTALLATION
The installation is to be carried out exclusively by qualified specialists, according to the
following instructions and in compliance with valid laws.
4.1 Preparation for installation
• Place the machine on an even and stable surface.
•
Make sure that the machine is on a water-resistant surface in case of water spillage
or leakage.
• Never place the machine on hot surfaces.
4.2 Electrical connection
• Make sure that the local main voltage supply corresponds to the information given
on the type plate on the front panel of the espresso machine.
• Make sure that you use the correct power plug for your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord / do not use a multiple socket.
5. FIRST USE
5.1 First use
Read the instruction manual carefully before operating the machine.
Prior to starting the machine, check if:
• the steam and hot water valves are closed.
• the machine is switched off. (Power switch in lower position.)
• the power cord is disconnected.
• the drip tray is inserted accurately.
• the machine is placed on a water resistant surface.
To Next Page
Loading...
