As you exercise,
you will be
prompted to keep
your pedaling
pace near the tar-
get rpm setting for
the current seg-
ment. When an upward arrow appears in the dis-
play, increase your pace. When a downward
arrow appears in the display, decrease your pace.
When no arrows appear, maintain your current
pace.
Important: The target rpm settings are intend-
ed only to provide motivation. Your actual
pace may be slower than the target rpm set-
tings. Make sure to exercise at a pace that is
comfortable for you.
If the resistance setting for the current segment is
too high or too low, you can manually override the
setting by pressing the Quick Resistance buttons.
Important: When the current segment of the
program ends, the pedals will automatically
adjust to the resistance setting for the next
segment.
Perform the first strength exercise when
prompted.
When the first strength exercise segment begins,
the name of the first strength exercise will appear
in the display for a few seconds. The time will
pause and flash in the display.
Step off the elliptical exerciser and prepare to
begin the first strength exercise. Perform repeti-
tions of the exercise as directed by the personal
trainer. Exercise with a slow, steady motion; do
not perform more than one repetition during each
interval indicated by the personal trainer. The dis-
play will also count the repetitions as you perform
them.
Note: Refer to the accompanying exercise chart
to see the correct form for each exercise. When
performing lunges, alternate legs with each repe-
tition. When performing dumbbell rows, perform
half the repetitions with your right arm and half
the repetitions with your left arm. The strength
exercises require the use of dumbbells and an
inflatable exercise ball (not included). To pur-
chase dumbbells or an exercise baH, call the
toll=free telephone number on the front cover
of this manual
Continue the cross trainer program.
When you have performed the recommended
number of repetitions, the words START STRID-
ING will appear in the display. To continue the
cross trainer program, step onto the exerciser and
start pedaling. The pedals will automatically
adjust to the resistance setting for the next seg-
ment.
The program will continue in this way until the last
segment ends. To stop the program at any time,
stop pedaling. A tone will sound and the time will
begin to flash in the display. To restart the pro-
gram, simply resume pedaling.
Follow your progress with the display.
See step 4 on page 14.
Measure your heart rate if desired.
See step 5 on page 15.
Turn on the fan if desired.
See step 6 on page 15.
When you are finished exercising, the console
will turn off automatically.
See step 7 on page 15.
16
To Next Page
Loading...
Need help?
General
